Cable Glands & Brass Electrical Parts manufacturers in India

Cable glands secure and seal a cable where it enters equipment, and are made in brass, stainless steel and plastic in single- and double-compression, armoured and flameproof types. Jamnagar in Gujarat is the main Indian centre for brass versions, alongside earthing accessories, lugs, terminals and turned electrical components. The gland must match the cable construction and the environment. These are small parts with large consequences: a poorly sealed gland lets moisture into a panel, and a wrong type in a hazardous area is a safety hazard. Specify the cable, thread, environment and certification clearly, and treat certificates as something to verify rather than assume.

1. Start from the cable: its outer diameter, whether it is armoured, and the sheath material. The gland’s clamping range must fit.
2. Pick the thread: metric, PG or NPT, and the length needed for the enclosure wall.
3. Decide the protection needed. For wet or dusty places, ask for an ingress-protection rating; for hazardous areas, flameproof or increased-safety certification is required.
4. Choose the material by environment: brass for general use, nickel-plated brass or stainless steel for corrosive or marine conditions.
5. For armoured cable, check that the gland grips the armour and provides earth continuity.
6. Ask for test reports and the certificate for any hazardous-area gland, and verify it with the issuing body.
7. Check plating quality and thread accuracy on a sample before ordering volume.
8. Ask about packing and marking, since glands of different sizes mixed in a carton cause mistakes on site; sizes should be clearly marked on each part or bag.

• ElectricalCable entry for panels, motors and junction boxes.
• Oil & GasFlameproof glands for hazardous areas.
• Renewable EnergyWeatherproof glands for solar and wind installations.